Starrett SR200 Surface Roughness Tester Bedienungsanleitung PDF herunterladen (Seite 23)

SR200 Speciﬁcations subject to change 5.3

Measure before print pressing PRINT  key before measurement

No parameter selected pressing PRINT  key before selecting printout parameters

Printer not connected

pressing PRINT  key when printer not connected or no computer

connected to receive dump data.

Printing cancelled

pressing PRINT  key during data transmission to printer (stop

printing). Message displayed for 2 seconds.

Measurement

cancelled

Pressing MEASURE  key during traverse (stop traverse)

Measure before data

dump

Attempted data dump before measurement

Speciﬁcation

Battery

Alkaline: minimum 600 measurements of 4mm measurement length

Ni-Cad: minimum 200 measurements of 4mm measurement length

Size: 6 LR 61 (USA/Japan)

Traverse Speed 1mm/sec

Measurement metric/inch units

Cut-off values 0.25mm, 0.8mm and 2.5mm (0.01in, 0.03in and 0.1in)

Traverse lengths 0.25-25mm (0.05-0.98in)

Display LCD-matrix, 8 lines x 20 characters, alphanumeric

9 pin D-connector female. Containing RS232 hardwired handshake

(RS232 level).

Accessory socket

Transmit function only hardware implemented.

Remote start (5V logic)

Remote start: short to ground.

Constant power on instrument (5V logic)

When connected to Ground, constant power is on

RS232 Output

Printer Conﬁguration

If SPC is on

Baud rate 4800 Baud

Parity Even

Data bit length 7 bits

Printer head disabled

If SPC is off

Baud rate 9600 Baud

Parity Odd

Data bit length 8 bits

Printer head enabled

Output to printer (in ASCII characters) or pre-selected parameters and provided that G is pre-

selected, a readout of dc corrected surface proﬁle.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Starrett SR200 Surface Roughness Tester Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Starrett SR200 Surface Roughness Tester